Image of Site Logo


Where Crocheting is Just Plain Fun


Buy From Amazon
Buy From Amazon
Point Tracker
Not activated.
Click to Activate tracker.
Your points account click tracker is not activated! Click this image to activate your tracker.<br>  Click this image to log into your account.


Loopy Beaded Bracelet

Loopy Beaded Bracelet Designed By Julie A. Bolduc

This bracelet is made with memory wire, beads and a Cotton/nylon yarn! It is fun to make and would look great with any casual outfit!
Click Here to Download the PDF Version

    Materials Needed

  • Bernat Cool Crochet, cotton/nylon yarn in Denim.
  • 144 white size 6 Seed beads, e beads or 4mm beads with 1.5-2mm hole
  • 19 round beads or pearls 8mm.
  • 1 lobster claw or magnetic clasp
  • 1 and a half coils of silver colored bracelet memory wire
  • Size F/5 or 3.75mm aluminum crochet hook
  • Tapestry needle and fine needle that fits through Size 6 Seed beads
  • Memory Wire Cutters
  • Round Nose Pliers

Yarn Thickness: 2mm
Gauge: 6sc = 1"
Finished Size: Fits an adult 7¼" wrist but can be adjusted to fit any wrist while it is being made.
Skill Level: Intermediate

Loopy Beaded Bracelet With Clasp

Instructions


Step 1: String on all of the 144 size 6 seed beads first.

Step 2: *Ch2, pull up a bead, ch3. Slst in 5th ch from hook. Repeat from * until you use up all of your 144 beads. Ch1 to secure. Fasten off, weave ends into work. Set aside.

Step 3: With your round nose pliers, make a small loop at one end of your memory wire going with the curve of the wire. Make this loop big enough to latch your clasp to.

Step 4: Place an 8mm bead onto the memory wire. Push it all the way to the loop you just made.

Step 5: *Run your memory wire through 8 of the stitches where you made your slip stitches on your crochet work. Slip on another 8mm bead. Repeat from * until all of your 19 round 8mm beads are used up and your crochet work is all on the memory wire.

Step 6: To finish your bracelet, push your crochet work tight against the first bead and loop. Trim your memory wire so the straight end is about an 1/8" away from the loop when you try it on your wrist. You need this space to allow for the clasp. My clasp and 2 loops took up 3/4" of space. You want your bracelet to float on your wrist but not dangle. Make a small loop on your other end making sure the loop is big enough to fit the loop part of your clasp on the loop. Close the loop up tight once your clasp is attached. Fluff up the loops of the crochet work and adjust it so it is evenly dispersed on your wire.

Design written on Sunday, July 3, 2016. Copyright ©2016 By Julie A. Bolduc p107042

JPF Crochet Club where Crocheting is Just Plain Fun
This crochet pattern is for personal use only and is not to be resold.