Bone Ring Bracelet

Designed By Julie A. Bolduc

This pretty bracelet is made with 5 plastic 1" bone rings. They are joined as you make each one on the last round. Then the clasp is attached after all of the ends are woven in. You should be able to make this bracelet in about 3 or 4 hours.

Materials Needed
Size 10 Crochet cotton DMC Cebelia Medium Rose was used in the example.
5 1" plastic bone rings
1 lobster clasp or desired clasp
2 jump rings
jewelry pliers
Tapestry needle for weaving in ends

Thread Size: 10thread
Gauge: 10sc=1"
Finished Size: 8¼" long x 1½" wide
Skill Level: Beginner to intermediate

Instructions
1st Ring
RND 1: Tie thread on to ring. Work 42 sc in ring. Join w/slst to first sc.

RND 2: Ch1. Sc in each of the next 6 sc. Ch3. *Sc in each of the next 7 sc. Ch3. Rep from * around. Join w/slst to ch1. Fasten off.

2nd Ring
When joining rings. hold previous ring, back side facing to the back side of the current ring.

RND 1: Tie thread on to ring. Work 42 sc in ring. Join w/slst to first sc.

RND 2: Ch1. Sc in each of the next 6 sc. Ch1. Slst in any ch3 sp of previous ring. Ch1. Sc in each of the next 6 sc of current ring. Ch1. Slst in next ch3 sp of previous ring. Ch1. *Sc in each of the next 6 sc of current ring. Ch3. Rep from * around to beginning of round. Join w/slst to ch1.Fasten off.

3rd Ring
RND 1: Tie thread on to ring. Work 42 sc in ring. Join w/slst to first sc.

RND 2: Ch1. Sc in each of the next 6 sc. Ch1. Slst in bottom right ch3 sp of previous ring. Ch1. Sc in each of the next 6 sc of current ring. Ch1. Slst in bottom left ch3 sp of previous ring. Ch1. *Sc in each of the next 6 sc of current ring. Ch3. Rep from * around to beg of round. Join w/slst to ch1. Fasten off.

4th & 5th ring.
Repeat as for 3rd ring.

Finishing
Lay the bracelet down in front of you. Join thread in top right ch3 sp of the very top ring. [Ch2. Dc in each of the next 3 sc. Dc, ch3, dc in next sc. Dc in each of the next 3 sc. Ch2. Slst in next ch3 sp. Fasten off and weave ends into back of work.]

Turn the bracelet around so the other end is at the top and repeat bet [].

Using jewelry pliers, attach clasp to the ch3 spaces at the ends of the bracelet.

Design written on Thursday, July 19, 2001. Copyright ©2001 By Julie A. Bolduc